This wiki is out of date, use the continuation of this wiki instead

From FenixWiki

Revision as of 21:00, 19 August 2007 (edit) Sandman (Talk | contribs) ← Previous diff		Revision as of 21:01, 19 August 2007 (edit) (undo) Sandman (Talk | contribs) m (→Example) Next diff →
Line 13:		Line 13:
	<pre>		<pre>
	Begin		Begin
		+
	square();		square();
-	Loop	+
		+	Repeat
	frame;		frame;
-	End	+	Until(key(_ESC))
		+
		+	exit();
		+
	End		End

---

Revision as of 21:01, 19 August 2007

Definition

The frame; command tells the interpreter when a process is done for one game cycle. When the frame; is reached, the screen is updated. If there are several processes running, the screen is updated once every process has reached its frame; statement.

It is commonly used in loops of processes that should do something like moving around by a certain amount of pixels per game cycle (or per frame).

A possibility is to adjust the amount of cycles to wait. frame(100); would wait one cycle (100%), same as frame;. However frame(200); will wait two cycles (200% means the frame statement provides for 200% frame). So frame(50); will wait a half cycle or otherwise said, it will make a loop run twice per frame.

Example

Begin

    square();

    Repeat
        frame;
    Until(key(_ESC))

   exit();

End

Process square()
Begin

    graph = new_map(5,5,16);
    map_clear(0,graph,rgb(255,255,255));

    Loop
        x += 2 * (key(_right)-key(_left));
        frame; //<-vital part
    End

End

This example process would give you a square you can move around the screen by 2 pixel before it gets showed again, before the game cycle is over, before the frame; happens. If there would be no frame; in the loop, it would just run forever and the interpreter would wait forever and wait for the frame; which would result in freezing.